Method 4: At the command prompt, type netsh int ip reset resetlog. Visit our Microsoft Answers Feedback Forum and let us know what you think. Was this reply helpful? Yes No. Sorry this didn't help. Thanks for your feedback. This thread is locked. You can follow the question or vote as helpful, but you cannot reply to this thread. To determine the value of DisabledComponents for a specific set of bits, construct a binary number consisting of the bits and their values in their correct position and convert the resulting number to hexadecimal.
For example, if you want to disable 6to4 interfaces, disable Teredo interfaces, and prefer IPv4 to IPv6, you would construct the following binary number: When converted to hexadecimal, the value of DisabledComponents is 0x2A.
The following table lists some common configuration combinations and the corresponding value of DisabledComponents. You must restart the computer for the changes to the DisabledComponents registry value to take effect. Please click here if you are not redirected within a few seconds. Search :. Windows Vista. Automatic address configuration An IPv6 host that is not a router can be automatically configured by using the following: 1.
The only benefit I can see so far is if you use it with colinux and probably other PC virtualization software to capture the traffic between Windows and the virtual machine. As it stands, I can connect my loopback adapter to a virtual router interface and capture ping, arp, etc.
A commercial network sniffer called CommView from TamoSoft allows you to capture packets on the localhost network adapter but it dissects fewer protocols, so you can capture packets with CommView and save them into a file and open it with Wireshark.
Doing so, every network traffic from your machine to itself will use the physical network interface, it will then go to the gateway, back to you. Therefor, you will see each packet twice, but it can be filtered on the view.
Be careful, since your machine will use the actual network to talk to itself, it may overload the network. It may be wise to remove the new route once you are done with the tests:. After filtering out the duplicate packets in the file, which contained the source IP address of 0. Some packets were clearly ordered incorrectly, but it was easy enough for me to spot them and tell what was going on.
The GetInterfaceInfo function obtains the list of the network interface adapters with IPv4 enabled on the local system. This buffer must be allocated by the caller. The correct way to use the GetInterfaceInfo function is to call this function twice. A buffer can then be allocated of the required size using the value pointed by the dwOutBufLen. Then the GetInterfaceInfo function can be called a second time with a pointer to this buffer passed in the pIfTable parameter and the length of the buffer set to the size of this buffer.
Information on the loopback interface is returned by the GetIpAddrTable function.
0コメント