Zenith 80 manual

Zenith Superdry SD Manuals. Zenith RCM Manuals. Zenith Royal Regent Manuals. Zenith Heat Pump Pumps Installation and maintenance manual 12 pages, 0. Zenith Indoor Furnishing W Assembly instructions manual 13 pages. Zenith HydroTap G4 Manuals. Zenith Victoria Pavilion Manuals. Zenith Therm-X Pro Manuals. Zenith Therm-X series Manuals. Zenith Monitor C27V28 Operating manual 68 pages, 1. Zenith Monitor CV Service manual 14 pages. Zenith DT2 Series Manuals.

Zenith Monitor L30W26 Installation and operating manual 56 pages, 3. Zenith Monitor P42W22 Owner's manual 56 pages, 6. Zenith C - Heath - Traditional Manuals. Zenith EZ hangup Manuals.

Zenith P42W34H and Manuals. Zenith Celsius Arc Manuals. Zenith Celsius Cube Manuals. Figures from to 2 on the exposure time scale show values of the exposure times in fractions of a second and from 1 to 30 show whole seconds. Black figures on the exposure time scale of the calculator correspond to figures of the exposure time dial scale.

The exposure time and the appropriate diaphragm chosen depending on conditions of photographing should be correspondingly set on the camera and on the lens. Slightly pulling up the exposure time dial and turning it round its axis set the selected exposure time figure against the index mark in the middle of the dial, sink the dial and fix it.

The figures on the exposure time dial indicate fractions of a second, and "B" indicates a hand-controlled exposure time. To obtain slow shutter speed you should cock the shutter, set the exposure time dial against "B", press the shutter release button and turn it counterclockwise as far as it goes. After exposure return the release button to its initial position. Notes: 1. The exposure time can be set both with cocked and released shutter.

Be sure to push the paper under the clamps. Turn the roll-holder lock counter-clockwise and the paper is held in this position. Fasten the paper tongue into the empty spool and turn the knurled knob so the paper lies flat. The loaded roll-holder can now be inserted in the magazine. Turn lock clockwise and then the holder will be locked and the paper released.

Open the window the magazine and wind the film with the loading key until figure "1" appears. Now turn the loading key counterclockwise until stop when figure "l" will appear in the film counter window.

The slide This is your safeguard against fogged film. Treat it carefully and keep it free of dust. It is part of a foolproof system; when the slide is completely in you cannot fire the shutter there are no missed shots with the Zenith 80 , when the slide is out you cannot detach the magazine: Always insert the slide at right angles to the body of the camera to avoid light leakage.

To remove the lens, grasp the milled collar at its base with your right hand. Press the lens lock release, turn the lens 3 of a full turn counter-clockwise as far as it will go. The Zenith 80 is fitted with variable synchronization suitable for both bulb and electronic flash.

The synchronizer control shown below incorporates a single 3 mm. To adjust the synchronization, rotate the control, by means of the small protrusion, until the black dot is aligned with the required symbol.

In order to fit these filters to the camera it is first necessary to set the lens to 0. NOTE: Zenith used different chassis in the same model on occasion. If the model has two chassis listed, select the correct chassis. If not purchasing an Instant Download use arrow , it normally takes up to 24 hours to receive the download instructions via email but please allow 1 - 2 business days.